The sales are on NOW!  Click here for amazing holiday savings!

10 Meter Radio Parts

Out-of-stock
EKL

The RFX75 is an RF final output stage and low pass filter designed as a replacement and/or upgrade for most 10-meter amateur transceivers.  The RFX75...


Features: Echo microphone for the Magnum 257 and 257HP radios.  Microphone is powered by the radio, does not require a battery.  Echo volume...

In stock
+

Factory replacement coarse fine clarifier for the Galaxy DX88HL radio.  This internal replacement part requires soldering to install.  Please...

In stock
+

Replacement 10.695 MHz crystal for Cobra 150GTL 10 meter radio.  This internal part will require soldering.  Please see our returns policy for...

In stock
+

For use with new Galaxy 10 meter radios.  Applications include High current, high speed switching Solenoid and Relay drivers DC-DC & DC-AC...

In stock
+

Cobra AMN-30740-VA LED Antenna Warning Light.  This is a factory replacement antenna warning light for Cobra radio.  This internal CB component...

In stock
+

Replacement 10 ohm 1 watt resistor for Cobra 150GTL.  This internal part will require soldering.  Please see our returns policy for important...

In stock
+

Factory replacement Cobra FCN-455A5-CB Ceramic Filter 455KHz. This internal part will require soldering.  Please see our returns policy for important...

In stock
+

Replacement 4.194MHz crystal for Cobra 200GTL 10 meter radio.  This internal part will require soldering.  Please see our returns policy for...

In stock
+

This is a factory replacement power cord strain relief for the Cobra 200GTL.  This device is attached to the power cord where it leaves the radios...

In stock
+

Cobra DRB-IN60D-CA Diode IN60P.  This internal part will require soldering.  Please see our returns policy for important information regarding...

In stock
+

Factory replacement calibration dial for Cobra 150GTL 10 meter radio.  This internal part will require soldering.  Please see our returns policy...

In stock
+

Replacement 10.6975MHz crystal for Cobra 200GTL 10 meter radio.  This internal part will require soldering.  Please see our returns policy for...

In stock
+

Replacement mode switch for the Cobra 150GTL.  This internal part will require soldering.  Please see our returns policy for important information...

In stock
+

Factory replacement transistor for Cobra 150GTL and 200GTL 10 meter radios.   This internal part will require soldering.  Please see our...

In stock
+

Factory replacement IC for Cobra 150GTL and 200GTL.  This internal part will require soldering.  Please see our returns policy for important...

In stock
+

Cobra RSC-222ZN-JA RAS Trimmer 2.2K.  This internal part will require soldering.  Please see our returns policy for important information...

In stock
+

Internal part for a Cobra 150GTL

In stock
+

Factory replacement tuning coil for Cobra 150GTL and 200GTL 10 meter radios.   This internal part will require soldering.  Please see our...

In stock
+

Bottom half cover for the Cobra 150GTL with attached speaker. 

In stock
+

Factory replacement capacitor for the Cobra 150 GTL. This is an internal part that requires soldering.  Please see our returns policy for important...

In stock
+

Factory replacement antenna connector for Cobra 150GTL and 200GTL 10 meter radios.  This internal part will require soldering.  Please see our...

In stock
+

Cobra 830-00098-AA Push Button for Noise Blanker HI Power and Roger Beep

In stock
+

This is a factory replacement heat sink for the Cobra 150GTL.  Replacement of this part may require some technical skill.  Incorrect installation...

In stock
+