A good PA horn can come in handy on the trail or on the job. Any time you need to talk to someone outside the vehicle you can flip a switch on your radio and be broadcasting over the PA in seconds. This five inch PA horn from Kalibur is the right balance of size and power for most CB applications.
The inside diameter of the horn is 5 inches, but the overall outer measurement is actually 5 3/8 inches. It tapers down to 3 inches at the back. It stands about 5 1/2 inches tall when pointed straight forward on the mount. The mount is 2 3/4 inches at its widest point. The back two mounting holes are 1 1/2 inches center to center. They are both 2 inches from the front mounting hole. The horn will swivel about 110 degrees on the mount, going from pointing straight up to angled down slightly.
The speaker wire for the horn is 10 feet long, which is enough to go from the most common mounting locations (under the hood or on top of the cab) to your radio. The wire ends in a 3.5 mm plug that will fit the PA jack for any CB radio.
The 8 ohm speaker will handle up to 15 watts of power, which is more than any CB puts out of the PA jack. The audio is fairly loud, but this is not an amplified speaker. If you need to be heard over a diesel or a noisy work area, an amplified PA speaker may be what you need.
- 15 Watt
- 8 ohm
- 5 inch PA horn
- 10 foot cord and 3.5mm plug
No posts found