MK748R Trunk lip mount kit [MK748R]

by FireStik

The trunk lip bracket slides over trunk edge (normally between the trunk deck and the rear window). Two set screws are tightened from the underside to hold the bracket in place. No holes are required on the vehicle. The rearward side of the bracket has support feet with rubber bumpers to protect the vehicle finish. The mount comes complete with a K-4 antenna stud and the allen wrench to tighten the set screws. Recommended for antennas up to 3ft (92cm).

Physically, the mount is 2" (50mm)wide and 2.5" (63mm) deep. It stands 1" (25mm) above the vehicle surface without the stud mount, which will add of 2.1" (53mm) when in place. The gap between the movable and unmovable areas (trunk deck and vehicle body) needs to be about 0.100" (3mm) to accomodate the mount. Furthermore, the underside requires about 0.5" (13mm) to accomodate the bottom of the bracket with set screws.

• No Hole Installation
• Includes 18' Professional Grade Fire-Flex Coax Cable
• Hooks Over Trunk Lip and Secured by Allen Screw on the Bottom
• Supplied PL259 Connector not Soldered on for Easy Routing
• As with All FireStik Kits, Included is a Free Microphone Hanger

SSM-1 Professional Ball Mount And Spring	3605119 4 5/8 Inch Wide Mounting Bracket PRO520 PRO510 19DX	K8 18-Foot Single Antenna Coax Cable
iC-56 102 Inch Stainless Steel Whip CB Antennas	CGA Coax Grommets	BT7259 Twist on PL259 with Rubber Boot