FireStik SSJ4A crimp-on Jeep Wrangler Fender Antenna Mounts were designed to be as rugged as the vehicles they are installed on.
The FireStik SSJ4A mount was specifically designed for the 1997 and newer Jeep Wranglers. The TJ series of Jeep's legendary Wrangler. The SSJ4A attaches to the front fender lip under the vehicles hood (either left or right side). Once properly installed all mounting hardware and holes are hidden from view.
Position the Jeep fender mount forward on the fender closer to the fender bolt if you use your Jeep Wrangler for aggressive off-highway driving. The SSJ4A is a 12 gauge all stainless steel antenna mount that resists weathering and radio electronic crushing rust.
High quality coaxial cable that is a little longer than the cable run for your Jeep will allow you some slack if you ever need to reroute your coax. FireStik does recommend 18 feet of coax with their products for best performance.
The SSJ4A will readily support antennas that stand 4 feet tall. An antenna shock absorbing spring will go a long ways to preserving your antenna, mount, and fender if you ever inadvertently strike a tree limb or if your significant other decides to pull your Jeep into the garage. The standard 3/8x24 threaded FireStik stud mount readily accepts all compatible antennas and accessories.
The FireStik Jeep Fender mount is also available with hoop connectors and in a complete CB antenna mount kit.
Jeep there's only one. Equip yours with the best - get a FireStik Fender CB antenna mount for go anywhere communication!
Antenna
FireStik's SSJ4A is a sturdy mount that can hold up to 4 foot antennas safely. The SSJ4A mount accepts 3/8 x 24 threaded CB antennas. A CB antenna spring is recommended for this mount.
Coax
The FireStik SSJ4A Jeep antenna mount requires the use of coax with PL259 connectors on both ends. We recommend a cable with a removable PL259 for easier install.
Product features
- SSJ4A Jeep Fender Mount with S0239 Stud
- For 1997 to 2006 Jeep Wranglers
- Left or Right Side of Hood
- 12 Gauge Stainless Steel Mount
- All Mounting Hardware Hidden Under the Hood
- Mount Accepts Standard 3/8" x 24 Threaded Antennas
- Securely supports antennas up to 4 feet (122 cm) tall
- Still made in the U.S.A.
- Two Year warranty
Additional Info
No posts found