Noise Clipper CB Radio Noise Suppressor from ProComm improves the dynamic range of CB or Amateur Radio. Amplifies the signal and reduces the noise from electrical interference. Installs in the antenna line between the radio and antenna, or between the linear and radio if you have a linear.
The Noise clipper is easy to install. The CB and Ant connections on the Noise clipper are SO239 and only require using a coax jumper with PL259 connectors and hand tightening for in-line antenna to device installation.
Three way selection switch for off, low, or max clip setting. You're in control with the Noise clipper from ProComm, Inc.
Please note that installing this device in the antenna line requires an extra CB coax jumper to go from the device to your radio.
If you are looking for a product that will help reduce and/or eliminate engine noises/interference, check out the AWNSFL noise filter.
- Three way switch for off, low clip, and max clip
- Frequency range: 24-30 MHz
- Maximum power input: 50 Watts
- Attenuation: 0-30dB
Additional Info 1
No posts found